2015-06-28 Maschine stoppt unerklärlicher weise

2015-06-21 Lüfter, Soft Limits, Rampen und max speed

GRBL 0.9g Config

>>> $$
$0=10 (step pulse, usec)
$1=25 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=6 (dir port invert mask:00000110)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=3 (status report mask:00000011)
$11=0.020 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=0 (report inches, bool)
$14=1 (auto start, bool)
$20=1 (soft limits, bool)
$21=1 (hard limits, bool)
$22=1 (homing cycle, bool)
$23=0 (homing dir invert mask:00000000)
$24=100.000 (homing feed, mm/min)
$25=1000.000 (homing seek, mm/min)
$26=250 (homing debounce, msec)
$27=1.000 (homing pull-off, mm)
$100=400.000 (x, step/mm)
$101=400.000 (y, step/mm)
$102=400.000 (z, step/mm)
$110=1500.000 (x max rate, mm/min)
$111=1500.000 (y max rate, mm/min)
$112=400.000 (z max rate, mm/min)
$120=50.000 (x accel, mm/sec^2)
$121=50.000 (y accel, mm/sec^2)
$122=50.000 (z accel, mm/sec^2)
$130=510.000 (x max travel, mm)
$131=560.000 (y max travel, mm)
$132=200.000 (z max travel, mm)

2015-03-07 GRBL Interpreter aufgebaut

GRBL Version 0.9 auf einem Arduino Uno. Gehäuse mit SUB-D 25 Pol besorgt, wo der reinkommt [typ_o]

Projekte/CNC Fräse/Logbuch (zuletzt geändert am 2016-07-22 05:24:48 durch typ_o)